SLB615D POWERCELL® load cells provide extremely high accuracy up to OIML R60 C10 and NTEP 10000d III M which is three times better than typical. The internal microprocessor continuously compensates for environmental factors to provide the most accurate measurements and offers active condition monitoring of key parameters. The SLB615D load cell is optimal for any multi-load cell scale when accuracy and reliability are key.
POWERCELL® load cells are easy to install, connecting to each other and the indicator in a simple daisy-chain network. Data transmission is via CAN Bus for a robust digital signal not affected by cable gauge and length, dampness, etc. No junction box is required, thus eliminating a common source of error. The load cells have M12 industrial cable connectors allowing the load cell or cable to be replaced independently without affecting system performance
Load cell failures very often go undetected in analog systems. With POWERCELL® load cells this cannot happen. The weight information from each load cell is handled separately for active condition monitoring by the indicator. Load cell overload or failure, out-of-symmetry errors, or out-of-range temperature signals are recognized immediately and corrective action initiated, often allowing the scale to operate until the load cell is replaced.
Every POWERCELL® load cell is equipped with an onboard microprocessor, and as part of the manufacturing process, the load cell's calibration data is stored in its memory. When the system is hooked up, the calibration data is transferred without error to the indicator, and the scale can be calibrated in seconds by CalFree Plus. In the unlikely event of a load cell failure, the calibration data for the replacement load cell is read and the scale can be recalibrated easily by CalFree Plus.
POWERCELL single-ended beam load cells are available with capacities from 220 kg to 4400 kg (500 lb to 10000 lb).
Yes, POWERCELL 615D is rated IP68/IP69k.
