Melting Behavior and Decomposition, Aspartame

SampleAspartame

Aspartame

 

Application

Inactive ingredient (sweetening agent)

 

Conditions

Measuring cellsDSC820, TGA850, F82 Hot stage microscope

Pans: DSC, TGA: Aluminum 100 µl, with pierced lid; FP82: sample holder with cover glass

Sample preparation: As received, no preparation

DSC measurement: Heating from 40 °C to 300 °C at 10 K/min

TGA measurement: Heating from 30 °C to 300 °C at 10 K/min

FP82 measurement: Start at 30 °C, heating at 10 K/min

Atmosphere: DSC and TGA: Nitrogen 80 cm3/min, FP82: Air, stationary environment, no flow

 

 

Interpretation

In the TGA curve the substance shows several weight loss steps. The SDTA signal recorded at the same time shows that all the reactions are endothermic. The DSC curve also gives the same information. The peaks are however sharper than in the SDTA signal because of the shorter time constant.

A slow but continuous weight reduction caused by the loss of moisture can be observed in the region between 40 °C and 110 °C. The step at about 129 °C is the elimination of the water of crystallization. This is confirmed by simultaneous measurements with the mass spectrometer. Finally, at about 187 °C, the substance decomposes by elimination of methanol (m/e = 31). The peak that can be observed at 245.7 °C in the DSC and SDTA curves corresponds to the melting of the decomposition product (3-carboxymethyl-6-benzyl-2.5-dioxopiperazine).

 

Evaluation

Onset temperature determination and integration of the melting peak of the DSC curve.

 

Peak

SDTA

Onset, °C

DSC

Onset, °C

DSC

ΔH, J/g

 

Effect

A40.0--moisture
B122.3122.729.8water of crystallization
C183.6185.4141.4decomposition
D239.4245.7121.3melting of the decomposition product

 

 

Step

TGA

Eval. Range, °C

TGA

Onset, °C

TGA

Step, %

 

Effect

A30-11079.61.1moisture
B110-150123.61.9water of crystallization
C180-225184.110.8decomposition

 

Additional information obtained with the hot stage microscope shows how the crystal structure of aspartame changes with temperature. To illustrate this, photographs were taken during the heating run at 30 °C and 224 °C. It can be clearly seen at 224 °C that fine needles are formed which correspond to the decomposition product.

 

 

 

Conclusion

For the elucidation of thermal behavior, the combination of TGA and DSC results with thermomicroscopy is often useful for the correct interpretation of complicated curves.

 

Melting Behavior and Decomposition, Aspartame | Thermal Analysis Application No. HB821 | Application published in METTLER TOLEDO TA Application Handbook Pharmaceuticals